Loading the 3D model (3.8 MB)…
AGMAY Technologies · design revision C · 19 November 2026
HL-30Heavy-lift hybrid VTOL cargo drone
30 kg of cargo, 7.4 hours or 772 km, and no runway. The HL-30 lifts straight up on eight electric rotors, then a fuel-injected engine flies it on its wing and recharges the lift batteries on the way. For take-off and landing the outer wings fold up, shrinking its width from 6.4 m to 2.7 m.
- Payload
- 30kg
- Endurance, 30 kg
- 7.4h
- Range, 30 kg
- 772km
- Max take-off mass
- 132.3kg
- Span · folded
- 6.4m 2.7m
- Best-range speed
- 104km/h
The model is the complete rev C CAD assembly, 541 parts. Use the buttons under it, or just scroll: the view follows the section you are reading.
Mission profile · 10 m AGL rule
One aircraft, two ways of flying
Near the ground the HL-30 is a multirotor; in the air it is an aeroplane. The changeover happens above 10 m, where the wings unfold and lock before the aircraft speeds up. Select a phase to see the aircraft in that state.
All eight lift rotors run while the wings stay folded. With every motor at its 26 kgf peak, thrust is 1.57 times the weight, and still 1.38 times with one motor out.
Above 10 m the panels swing down in 2.5 s and two shoot bolts per side drive home. The autopilot will not start the transition until all four read locked.
The pusher accelerates the aircraft while the rotors hold it up. Once the speed is well past the 23.1 m/s stall speed, the wing carries the weight and the lift rotors stop.
The 110 cc engine turns the 26-inch pusher at the 29 m/s best-range speed, which takes 4.2 kW at the shaft. Its 1.2 kW starter-generator refills the lift batteries in about 0.7 h.
The aircraft slows into the hover, folds its wings while still above 10 m, and settles on landing gear with a 60 mm shock-absorber stroke.
Fold joint · BL ±1,270 mm · hinge line WL 773
The folding wing
Each outer panel folds 90° up about a hinge line on the top skin, 100 mm outboard of its boom. Folded, the HL-30 is 2.7 m wide instead of 6.4 m, so it fits small landing sites. It also shows less side area to gusts in the hover: it holds a 13.5 m/s crosswind with the wings folded.
- Fold angle
- 0°
- Actuator
- 290 mm
- Shoot bolts
- In
- Up-lock
- Free
- Shoot bolts withdraw. Linear pin pullers draw two Ø8 mm steel bolts per side, 19 mm, out of the lower spar caps. This takes 0.5 s.
- The panel folds. A 1,500 N ball-screw actuator extends 87.6 mm and swings the 2.7 kg panel 90° up in 2.5 s.
- The up-lock engages. Over the last 3°, a spring bolt shoots 16 mm through a titanium flange on the hinge leaf and holds the folded panel, so wind loads do not reach the actuator.
Unfolding runs the same steps backwards: the up-lock is pulled, the panel comes down, and the shoot bolts drive home. Four switches report the bolts, and the autopilot needs all four to read locked before it will fly on the wing.
- Hinges
- Two Ti-6Al-4V knuckle hinges on the top skin at 20 % and 44 % chord, Ø8 mm 4340 steel pins. The hinge line sits 4 mm above the highest point of the wing so the panel swings clear.
- Spread locks
- Two Ø8 mm shoot bolts per side, at the main and rear lower spar caps, in double-cheek titanium clevises, each with a locked switch.
- Up-lock
- One Ø8 mm spring bolt per side in a titanium clevis on the end rib, 39 mm from the hinge axis.
- Actuator
- 1,500 N ball screw, 87.6 mm stroke, anchored on the lower skin at BL 960.
- Transport
- Pull the two hinge pins and the two lock pins and the outer panel comes off.
Fuselage stations · FS in mm from the nose
What is inside
The 25 L fuel tank and the 30 kg payload bay sit together in the middle of the fuselage, with the other systems in the bays ahead of and behind them.
Hybrid power · 48 V bus · 24S lift battery
Hybrid power
Two power paths share one airframe. Fuel feeds the engine for the long cruise. Batteries feed the lift rotors for the minutes of vertical flight, and the engine refills them in the air.
The hybrid layout is what makes the endurance possible. An all-electric version of the same airframe, with the engine and fuel replaced by 27.7 kg of battery, would fly only 1.38 h and 144 km.
- Lift
- 8 × 24S outrunner motors in four coaxial pairs, 26 kgf peak each, 40 × 13 in carbon propellers. Each motor is canted 3° on a wedge so its thrust adds yaw control.
- Cruise
- 110 cc two-stroke boxer twin with electronic fuel injection, 1.2 kW 48 V starter-generator, 26 × 12 in pusher on a carbon drive shaft.
- Battery
- Two 12S 22 Ah lithium-polymer packs in series: 24S, 88.8 V, 1.95 kWh, with a smart BMS on the CAN bus.
Structure · ultimate factor 2.0
Built in carbon
The airframe is all carbon fibre, sized to an ultimate factor of safety of 2.0: a third above the 1.5 that CS-23 and ASTM F3298 ask for. All 67 strength and stability checks across 32 load cases pass, and the smallest margin is +0.06.
- Skins: carbon and foam sandwich; the outer 2×2 twill ply is left exposed under a UV-stable clear coat.
- Wing: two spars with pultruded T700 carbon caps that run straight through the fuselage, and extra foam core that stiffens the skin between them.
- Tubes: filament-wound carbon booms, landing-gear struts and V-tail spars.
- Fittings: compression-moulded carbon with bonded stainless bushes; the fold joint is titanium and 4340 steel.
The 3D view spreads the 541 parts apart along their assembly directions. Press Explode again to put them back.
Payload bay · FS 1095 to 1805
Payload and safety
The 30 kg container rides inside the fuselage on two servo-latched hooks rated 100 kg each. It can be set down on the ground, lowered on a 15 m winch line from a 12 m hover at up to 1.5 m/s, or air-dropped under its own parachute.
- Recovery parachute: a ballistic canopy, fired by the flight controller or by an independent flight-termination system.
- Motor failure: the aircraft hovers on seven of its eight lift motors, with a thrust-to-weight of 1.38.
- Navigation and links: triple-IMU flight controller, two RTK GNSS receivers that also give heading, a long-range datalink plus a separate RC link, and an ADS-B transceiver.
- Fold interlocks: the wings unfold only above 10 m, and the aircraft will not transition until all four shoot bolts read locked.
For mountain work, a 5.7 kg high-altitude kit adds a turbo-normaliser, high-altitude propellers, ice protection and cold-soak heaters. With it the HL-30 HA delivers 20 kg to a post at 16,000 ft.